EZ SCADA Installation

EZ SCADA is a small, economical, SCADA or wireless Telemetry communication system featuring easy to use and install hardware.

Northern Data Systems presents Radio Telemetry SCADA Systems.

We call it EZ SCADA because there's only four EZ installation steps.

STEP 1: Mount the enclosure.

NEMA 4 enclosure offers installation flexibility.

Choose a good location.

Mounts directly to walls, struts, or other equipment.

Install the antenna.

STEP 2: Install the antenna.

Thread on the short range antenna.

Transmit from field sites to control room, or building to building.

Optional high gain antennas and cable available.

STEP 3: Connect your wires.

Uses standard 120 VAC power.

Connect your 4-20 mA (variable signal) wires for flow, level, speed, etc.

Connect your digital (on/off) wires to the digital points.

Turn it on!.

STEP 4: Turn it on!

Connect the back-up battery.

Energize the EZ SCADA circuit breaker in the enclosure.

Turn it on! LEDs and signal strength indicators tell you system status.

HOME | EZ Installation | EZ Spec Sheet | Contact us | NDS EZ SCADA Main page

EZ SCADA.com

SCADA telemetry kpsi, SCADA telemetering telemetry SCADA DIALER SCADA telemetry SCADA telemetry telemetering SCADA wireless SCADA SCADA SCADA SCADA SCADA SCADA ALARM DIALER ALARM DIALER SCADA SCADA SCADA SCADA
SCADA telemetry radio water wastewater rtu wireless nds alarm lift plant telemetering northern data systems remote terminal unit flow. station well tank wtp wwtp operator treatment environmental intrac moscad wetwell supervisory intouch modbus SDWA awwa sewerage potable pump plc spread spectrum. level instrumentation wonderware metering acquisition utility computer software SCADA SCADA